Siderale
Bio
To create something new you have to start again, with great intent you to disconnect from the past.
One of the things we've learned is the importance of listening, because as we all know, the very best ideas can very often come from the quietest voice.
Ideas are extremely slight; ideas are not predictable in terms of when you'll have them and so over the past two years we've created the environmental that we think really increases the probability of good ideas. When they actually arrive, we think to breed with care, to make it growth.
Our engineering department really is a workshop. We design three-dimensional objects and prototypes, design and making really should be inseparable. Behind the machine we made there is the headstrong attention to every single decision we made.
The hallmark of the group has been to be inquisitive and ask an awful lot of questions, we worked very hard to just have our heads down and ignore in some sense all the reasons why something shouldn't be possible.
Our Approach
Define, Simulation, Prototyping and Project.


Usually to create a new machine you need at least three important versions, one that is able to demonstrate the effectiveness of the process, another that is able to compete on small numbers and a third version that is finally able to operate on mass consumption. In Siderale, after having carefully defined the production process to be carried out, we make the most of the modern simulation capabilities of 3D modeling systems to obtain a very advanced project base. Then follows the creation of an advanced prototype that focuses the technologies only on those aspects that cannot be completely simulated and for which it is considered appropriate to involve our potential customers in the evaluation of the process. With this method we limit the costs and development times of the entire project.
Usually to create a new machine you need at least three important versions, one that is able to demonstrate the effectiveness of the process, another that is able to compete on small numbers and a third version that is finally able to operate on mass consumption. In Siderale, after having carefully defined the production process to be carried out, we make the most of the modern simulation capabilities of 3D modeling systems to obtain a very advanced project base. Then follows the creation of an advanced prototype that focuses the technologies only on those aspects that cannot be completely simulated and for which it is considered appropriate to involve our potential customers in the evaluation of the process. With this method we limit the costs and development times of the entire project.

NEWSLETTER

Sign up to stay up to date on our activities